| RATING | DC Input | - | 5V 3A |
| Practical Temperature Range | -25~85C | - |
| STANDARD ATMOSPHEIC CONDITIONS | Temperature | - | 5 TO 35 |
| Humidity | - | 45% TO 85% |
| Pressure | - | 86Kpa TO 106Kpa |
| MECHANICAL | Connection Force | After connecting and disconnecting using standard plug gauge 3 times | 0.5-2.0Kgf |
| Disconnection Force | After connecting and disconnecting using standard plug gauge 3 times | 0.8~2.0Kgf |
| TERMINAL STRENGTH | Static Load | 0.1N/m(1kgf/cm) applied to the tip of the terminal for 1 min in any direction | No damage, meets electrical and mechanical characteristics |
| ELECTRICAL | Contact Resistance | Measured at small current (100mA or less) at 1000Hz | 40m |
| Insulation Resistance | Apply 100V DC for 1 min between specified portions | 100M |
| Dielectric Strength | AC 100V rms (50~60Hz) for 1 min, trip current: 0.5mA, between specified portions | No damage, arcing, or breakdown |
| DURABILITY | Solderability Test | Terminal top dipped 1mm in solder bath at 2505 for 50.5 seconds | Solder wetting time 3 sec, Soldering area 75% |
| Resistance to Soldering Heat Test (Reflow) | Preheat: 180 for 120s, Peak Temp: 2605 within 20s | No deformation of case, meets mechanical and electrical characteristics |
| RESISTANCE TO SOLDERING HEAT TEST (Iron) | Soldering Iron Method | Bit Temperature 3305, Application Time 30.5 sec | No deformation of case, meets mechanical and electrical characteristics |
| HUMIDITY TEST | Storage Conditions | 402 and 90% to 96% humidity for 96 Hr, then 1 Hr at standard atmospheric conditions | - |
| HEAT TEST | Storage Conditions | 702 for 96 Hours, then 1 Hr at room temperature | No damage on appearance, meets mechanical and electrical characteristics |
| COLD TEST | Storage Conditions | -253 for 96 Hours, then 1 Hr at room temperature | No damage on appearance, meets mechanical and electrical characteristics |
| LIFE TEST | Without Load | 10000 cycles at a speed of 10 to 25 cycles/min | - |
| With Load (Rating Condition, Non-inductive) | 10000 cycles at a speed of 10 to 20 cycles/min | Contact Resistance 0.1, Disconnection Force 0.8 to 2.0N, meets mechanical and electrical characteristics |
| TEMPERATURE CYCLING TEST | Conditions | 5 cycles of specified temperature profile, then 30 min at room ambient | No deformation or cracks, Insertion & Extraction Force: 3 to 20N, Contact Resistance: Max.30m, Insulation Resistance: Min.100 M, Dielectric Withstanding Voltage: 100VAC/min (between terminals) |
| COLD & HEAT SHOCK TEST | Conditions | 5 cycles of specified temperature profile, then 30 min at room ambient | No deformation or cracks, Insertion & Extraction Force: 3 to 25N, Contact Resistance: Max.30m, Insulation Resistance: Min.100 M, Dielectric Withstanding Voltage: 500VAC/min (between terminals) |
